Course description - Electrical Service OmniCore

General objectives

After this course the participant should be able to perform an effective electrical troubleshooting on an OmniCore system.

Course objectives

Upon completion of this course, the student should be able to:

• Work systematically when troubleshooting.
• Troubleshoot based on fault symptoms/units.
• Use practices that is safe for both equipment and personnel.
• Update revolution counters.
• Calibrate the robot.
• Reinstall RW7 systems.
• Configure ABB IO units.

Participant

This training is targeted to service engineers and personnel performing electrical service.

Prerequisites

Participants must be able to read circuit diagrams and use a multi-meter.

Course contents

• Health & Safety
• Safety: Electrical Troubleshooting
• Electrostatic Discharge
• OmniCore Overview: Electrical Units & Components
• Introduction to troubleshooting
• Troubleshooting by fault symptoms
• Troubleshooting by unit
• Troubleshooting Exercises
• Revolution Counters
• Calibration
• Overview of system parameters
• Backup/Restore
• Reinstall Software
• IO Configuration of ABB Units

Course type

The course is teacher-led. About 50% of the course consists of exercises.

Course length

The course lasts for 3 days.

Explanation to course description

We schedule as many courses we can during one term, but some corses are only held upon demand. Are you missing a scheduled course, or if you wish another course than the scheduled, you can enter the waiting list for this course and we will contact you to discuss a proposal.

All courses are held in Swedish, but can be ordered to be held in English with minimum 4 participants. We can also customize a course after your need. Contact us on phone or e-mail for a suggestion.

Phone. +46 10-732 50 00
E-Mail [email protected]