Robotics Training Center
Course offers - Booking portal
Electrical Service OmniCore - Special
General objectives
After this course the participant should be able to perform an effective electrical troubleshooting on an OmniCore system.
Course objectives
Upon completion of this course, the student should be able to:
- Work systematically when troubleshooting.
- Troubleshoot based on fault symptoms/units.
- Use practices that is safe for both equipment and personnel.
- Update revolution counters.
- Calibrate the robot.
- Reinstall RW7 systems.
- Configure ABB IO units.
Participant
This training is targeted to service engineers and personnel performing electrical service.
Prerequisites
Participants must be able to read circuit diagrams and use a multi-meter.
Course contents
- Health & Safety
- Safety: Electrical Troubleshooting
- Electrostatic Discharge
- OmniCore Overview: Electrical Units & Components
- Introduction to troubleshooting
- Troubleshooting by fault symptoms
- Troubleshooting by unit
- Troubleshooting Exercises
- Revolution Counters
- Calibration
- Overview of system parameters
- Backup/Restore
- Reinstall Software
- IO Configuration of ABB Units
Course type
The course is teacher-led. About 50% of the course consists of exercises.
Course length
The course lasts for 3 days.
| Course | Electrical Service OmniCore - Special |
| Number | R500 |
| Date | 2026-02-16 – 2026-02-16 |
| Week | 08 |
| Price | SEK 20 700,00 |
| Location | Kundlokal Kundlokal |
| [email protected] | |
| Available places | 0 |
| Registration deadline | 2026-02-08 23:00 |
| Status | Fully booked, entry in waiting list possible |
| Date | Time |
|---|---|
| 2026-02-16 | 09:00 – 16:00 |
|
|
Bookings are made via the booking system edoobox This offer is aimed exclusively at tradespeople. Displayed prices are excluding VAT.
|